Mill guides are to help billet safely pass through rolling mill. Mill guides could clear oxide scale of billet, and make the surface of billet more smooth. Mill guides also could increase the strength of surface of billet. Hotion could develop and produce all kinds of mill guides for different rolling mill. 

     

             

Mill Guides                  

        

▲ Two Roller Entry Guide For Roughing Stand, Intermediate Stand, Finishing Stand.

▲ Four Roller Entry GuideFor Finishing Stand Of High Speed Rolling Line.

▲ Slit Rolling Guide For Two-sliting, Three sliting, Four sliting, Five sliting Stand.

▲ Twist Roller Guide For Finishing Stand Of Rebar Rolling Line.

▲ Exit Guide For Different Stands Of Rebars & Profile Rolling Line.

▲ Sliding Exit GuidesFor Roughing, Intermediate Stand.

      

Hotion guides are made with the material of Z40Cr or 2Cr13.

GB	ASTM	JIS	EN
Z40Cr	5140	SCr440	41Cr4

                    

                                

Guide Plates

Guide plates are installed in the roughing stands and intermedate stands, 

billets will go through the guide plates and come into the mill rolls. Hotion 

develops guide plates with the material of Z50CrMo and 2Cr13. This material 

have good wear resistance and better save cost. Hotion also would like to 

design guide plates according to the request of customers.

                            

GB	ASTM	DIN	NF	BS
2Cr13	CA-40	G-X20Cr14	Z20C13M	420C29

     

                     

Guide Rollers

Guide rollers have maximum consumption of all the spare parts for guides.

According to different working condition, Hotion could offer different material

such as Cr12MoV, Tungsten Carbide, Composite Tungsten Carbide.  

Composite tungsten carbide guide rollers are consisted of two parts, steel 

matrix and tungsten carbide layer. The normal depth of tungsten carbide 

layer is from 5-8mm.The maximun depth could be 20-30mm. The composite 

tungsten carbide guide rollers have better save cost and same wear resistance 

                                                      than tungsten carbide guide rollers.    

GB	ASTM	ISO
Cr12MoV	D2	X153CrMoV12

                                                                                                                                 

                                       

TMCP Equipments

Our TMCP equipments installed on the bar mill and high speed wire rod mill.

For rebars rolling, we have single strand, 2 strands, 3 strands, 4strands, 5strands,

TMCP; in high speed wire rod line we have pre-finishing TMCP and finishing TMCP.

WE shall design the TMCP as per the requirements of the customer.

                             

                                                                                       

                    

                       

Restbar

 Rest bar is for installing, supporting, and fixing mill guides, mounting and fixing at

entry and exit side of the mill stand. In severing conditions against water and dust,

adjusting threaded rod in the conventional rest bar will stick because of the rust and

dust. With an innovative water-dust-proof design, our rest bar shall not exposed to

such problem.

                 

                                     

Loopers

Our loopers are for bar mills and wire mill. We have sing/2/3/4/5 strands loopers for

bar mills. Those loopers are customized. We improved design from the structure of

the looper from front single cantilever to the structure with center pulling roller,

hence extend the lifetime of the bearings.

            

                     

                                                                              Metallurgical Solutions Provider